SATC_CI_CFG_SERIES_VIEW SAP Function module - View configuration of run series

SATC_CI_CFG_SERIES_VIEW is a standard SAP function module available within R/3 SAP systems depending on your version and release level. Below is the pattern details for this FM showing its interface including any import and export parameters, exceptions etc as well as any documentation contributions (Comments) specific to the object.

See here to view full function module documentation and code listing, simply by entering the name SATC_CI_CFG_SERIES_VIEW into the relevant SAP transaction such as SE37 or SE80.

Associated Function Group: SATC_CI_CFG_SERIE_DIALOG
Released Date: Not Released
Processing type: Normal fucntion module

Pattern for FM SATC_CI_CFG_SERIES_VIEW - SATC CI CFG SERIES VIEW

CALL FUNCTION 'SATC_CI_CFG_SERIES_VIEW' "View configuration of run series
  EXPORTING
    i_series =                  " cl_satc_ci_cfg_series  Series
  EXCEPTIONS
    CX_SATC_AC_BAD_STATE = 1    "               Invalid state
    .  "  SATC_CI_CFG_SERIES_VIEW

ABAP code example for Function Module SATC_CI_CFG_SERIES_VIEW

The ABAP code below is a full code listing to execute function module SATC_CI_CFG_SERIES_VIEW including all data declarations. The code uses the latest in-line data DECLARATION SYNTAX but I have included an ABAP code snippet at the end to show how declarations would look using the original method of declaring data variables up front. This will allow you to compare and fully understand the new inline method. Please note some of the newer syntax such as the @DATA is not available until a later 4.70 service pack (SP8).

DATA(ld_i_series) = 'Check type of data required'.
.

CALL FUNCTION 'SATC_CI_CFG_SERIES_VIEW'
  EXPORTING
    i_series =                   ld_i_series
  EXCEPTIONS
    CX_SATC_AC_BAD_STATE =       1
    .  "  SATC_CI_CFG_SERIES_VIEW

IF SY-SUBRC EQ 0.
  "All OK
ELSEIF SY-SUBRC EQ 1. "Exception
  "Add code for exception here
ENDIF.

ABAP code to compare 7.40 inline data declaration with original syntax

The below ABAP code uses the older none in-line data declarations. This allows you to see the coding differences/benefits of the later inline syntax. It may also be useful if you are using an older version of SAP as some of the newer syntax above, such as the @DATA is not available until 4.70 EHP 8.

DATA:

ld_i_series
 
 TYPE CL_SATC_CI_CFG_SERIES .


ld_i_series = 'Check type of data required'.