snc/permit_insecure_start SAP Parameter attribute - Permit to start insecure programs when SNC is enabled

snc/permit_insecure_start is a SAP Parameter attribute which is used to control Permit to start insecure programs when SNC is enabled information. This is available within R/3 SAP systems depending on the version and release level.

Below is the standard documentation available and a few details of the attributes values .

snc/permit_insecure_start profile paramerter attributes

Parameter Name: snc/permit_insecure_start
Description: Permit to start insecure programs when SNC is enabled
Default Value: 0
Parameter Type ( See IF_PARAMETER_TYPES): Boolean(BOOL)
Restriction Values:
Parameter Unit:
Parameter Group: SNC
CSN Component: BC-SEC-SNC
System-Wide parameter: No
Dynamic Parameter: No
Vector Parameter: No
Has Sub-Parameters: No
Check Function Exists: No

Parameter documentation

If SNC is activated (parameter snc/enable = 1 ), by default no programs that communicate without SNC are started by the gateway. With snc/permit_insecure_start this is permitted.

See SAP Parameter Documentation for full SAP documentation for this profile parameter.